Milling Tips / Holders Multi-Function End Mills Technical Information
Multi-Function End Mill (Long Flute Length) MTEM
Bottom Surface Shape After Hole Processing
■ Flat surfaces cannot be achieved during plunge and helical cutting when the desired hole diameter is 2 times or less than that of the end mill diameter.
- The maximum height of b will be the same as the height of a.
- The diameter of d2 is 2xφD1-φD2.
Groove and Pocket Milling Precautions
- There is a high possibility that swarf may clog the mill when transitioning from plunge to pocket milling.
- Groove milling after slant processing will facilitate swarf evacuation and thus prevent mill clogging.